Heated Oxygen Sensor (Sensor 1) Removal and Installation: Installation
WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure noting the followings.
- Tighten oxygen sensor (s) to specified torque.
Tightening torque
Heated oxygen sensor 1 a: 45 N.m (4.5 kg-m, 32.5 lb-ft)
- Connect connector of oxygen sensor(s) and clamp wire harness securely.
- After installing oxygen sensor(s), start engine and check that no exhaust gas leakage exists.