LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Verona Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine General Information And Diagnosis) >> Diagnostic Information and Procedures >> DTC P0111: Intake Air Temperature Sensor Circuit Performance >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
  1. Connect scan tool to DLC with ignition switch turned OFF.
  2. Turn ON ignition switch and clear DTC, pending DTC and freeze frame data in ECM memory by using scan tool and start engine.
  3. Check vehicle and environmental condition for:
    • Engine coolant temp. at engine start: 50 °C (122 °F) or lower
  4. Warm up engine to normal operating temperature and confirm that engine coolant temp. is within 74 °C (165 °F) or higher.
  5. Drive vehicle above 35 mph (55 km/h) for 3 min. or more.
  6. Stop vehicle with engine running at idle for 3 min. or more.
  7. Check pending DTC and DTC.
scientia non olet · About LEMON Manuals