DTC Table

WARNING: This page is about a different car, the 2006 Suzuki XL-7. However, it is still accessible from the selected car via links, so may be relevant.

DTC CHART

DTC on SCAN tool	Flashing pattern of DTC	Mode	Diagnosis
DTC on SCAN tool	No.	Mode	Diagnosis
NO DTC	12	Courtesy of SUZUKI OF AMERICA CORP.	No malfunction DTC below is detected.
C1213	13	Courtesy of SUZUKI OF AMERICA CORP.	"2WD <--> 4WD" switch circuit open	Diagnose trouble according to "Diagnostic Flow" corresponding to each DTC.
C1214	14	Courtesy of SUZUKI OF AMERICA CORP.	"2WD <--> 4WD" switch circuit short
C1215	15	Courtesy of SUZUKI OF AMERICA CORP.	"N" switch circuit open
C1216	16	Courtesy of SUZUKI OF AMERICA CORP.	"N" switch circuit short
C1217	17	Courtesy of SUZUKI OF AMERICA CORP.	"4L" switch circuit open
C1218	18	Courtesy of SUZUKI OF AMERICA CORP.	"4L" switch circuit short
C1221	21	Courtesy of SUZUKI OF AMERICA CORP.	Transfer shift actuator motor position sensor circuit open
C1222	22	Courtesy of SUZUKI OF AMERICA CORP.	Transfer shift actuator motor position sensor circuit short
C1223	23	Courtesy of SUZUKI OF AMERICA CORP.	Transfer fork switch circuit open
C1224	24	Courtesy of SUZUKI OF AMERICA CORP.	Transfer fork switch circuit short
C1225	25	Courtesy of SUZUKI OF AMERICA CORP.	4WD switch circuit open
C1226	26	Courtesy of SUZUKI OF AMERICA CORP.	4WD switch circuit short
C1227	27	Courtesy of SUZUKI OF AMERICA CORP.	4WD low switch circuit open
C1228	28	Courtesy of SUZUKI OF AMERICA CORP.	4WD low switch circuit short
C1231	31	Courtesy of SUZUKI OF AMERICA CORP.	Transfer shift actuator motor circuit open
C1232	32	Courtesy of SUZUKI OF AMERICA CORP.	Transfer shift actuator motor circuit short
C1233	33	Courtesy of SUZUKI OF AMERICA CORP.	Front axle lock actuator motor circuit open
C1234	34	Courtesy of SUZUKI OF AMERICA CORP.	Front axle lock actuator motor circuit short
C1243	43	Courtesy of SUZUKI OF AMERICA CORP.	Internal circuit malfunction of 4WD control module

NOTE:

When 2 or more codes are indicated by 2WD/4WD indicator, 4L indicators (in combination meter and on "4L" switch) and N indicator flashing pattern, the lowest numbered code will appear first.
Current DTC and history DTC can be identified by lighting and flashing of 2WD/4WD indicator, 4L indicators (in combination meter and "4L" switch) and N indicator as follows. However, if a multiple number of DTCs are set and one of them is a current DTC, these indicators keep flashing after turning ignition switch to ON position. Therefore, it is not possible to identify any of them as to whether it is a current one or a history one. (But SUZUKI scan tool will make identification possible.)

DTC CHART

	Current DTC is set. (Abnormality exists at present.)	History DTC is set only. (Faulty condition occurred once in the past but normal condition is restored at present.)
2WD/4WD indicator, 4L indicators (combination meter and "4L" switch) and N indicator after ignition switch ON	Keep flashing after turning ON for 2 seconds.	Turn off after turning ON for 2 seconds.
2WD/4WD indicator, 4L indicators (combination meter and "4L" switch) and N indicator when grounding diagnosis switch	Current DTC is displayed.	History DTC is displayed.