Transmission Shift Control Lever Removal and Installation: Installation

Reference: TRANSMISSION SHIFT CONTROL LEVER INSPECTION 

1. If control lever locating bolts (1) are replaced or retightened, torque them as specified below.

   Replacing of control lever locating bolts (1) requires thread lock cement.

   "B": Thread lock cement 99000-32020 

   Tightening torque 

   Transmission control lever locating bolt a: 17 N.m (1.7 kg-m, 12.5 lb-ft) 

2. Apply grease to pivot portions and seat, then install shift control lever.

   "A": Grease 99000-25010 

   Fig 1: Identifying Control Lever Locating Bolts & Grease Application Area

   Courtesy of SUZUKI OF AMERICA CORP.
3. Set shift control lever (2) to shift lever case.
4. With gear shift control case cover (1) pushed down by hand, turn gear shift control case cover (1) to clockwise.
   Fig 2: Identifying Gear Shift Control Case Cover & Shift Control Lever

   Courtesy of SUZUKI OF AMERICA CORP.
5. Install boot No. 1 (1) from inside of cabin and clamp it with a new clamp (2) securely.
   Fig 3: Identifying Boot No. 1 & Clamp

   Courtesy of SUZUKI OF AMERICA CORP.
6. Install boot No. 2 (2) with boot cover (3) and console box bracket (1).

   Tightening torque 

   Control lever boot cover bolt a: 15 N.m (1.5 kg-m, 11.0 lb-ft) 

   Fig 4: Identifying Boot Cover, Boot No. 2 & Console Box Bracket

   Courtesy of SUZUKI OF AMERICA CORP.
7. Install console box.
8. After fitting boot No. 3 (1) to covers (2), install covers (2) to center console boxes.
   Fig 5: Identifying Boot No. 3 And Covers

   Courtesy of SUZUKI OF AMERICA CORP.