DTC Troubleshooting
DTC TROUBLESHOOTING CHART
| Step | Action | Value (s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK
. Was the check performed? |
- | Go to Step 2. | Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK . |
| 2 | Check for a faulty connection or damaged terminal B at the Electronic Ignition (EI) system ignition coil and repair as needed. Is the repair complete? |
- | Go to Step 8. | Go to Step 3. |
| 3 | Check for a faulty connection or damaged terminal A31 at the Engine Control Module (ECM) and repair as needed. Is the repair complete? |
- | Go to Step 8. | Go to Step 4. |
| 4 |
Is the repair complete? |
- | Go to Step 8. | Go to Step 5. |
| 5 | Check the ignition control circuit for a short to voltage and repair as necessary. Is the repair complete? |
- | Go to Step 8. | Go to Step 6. |
| 6 | Check an open ignition control circuit and repair as needed. Is the repair complete? |
- | Go to Step 8. | Go to Step 7. |
| 7 |
Is the repair complete? |
- | Go to Step 8. | - |
| 8 |
Does the scan tool indicate that this diagnostic ran and passed? |
- | Go to Step 9. | Go to Step 2. |
| 9 | Check if any additional DTCs are set. Are any DTCs displayed that have not been diagnosed? |
- | Go to applicable DTC Table . | System OK |