LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Swift + >> Repair and Diagnosis >> Transmission >> Manual Transmission Clutch System >> Repair Instructions >> Clutch, Pressure Plate, and Pilot Bearing Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Pressure Plate
    GM1251807Courtesy of GENERAL MOTORS CORP.
  1. Coat the spline on the clutch disc with multi-purpose grease.
  2. Align the pressure plate and the clutch disc onto the flywheel using DT 46551  .
    3. NOTE: Refer to Fastener Notice .
  3. Install the pressure plate bolts.

    Tighten: 

    • For the hydraulic clutch type, tighten the bolts to 15 N.m (11 lb ft).
    • For the cable clutch type, tighten the bolts to 18 N.m (13 lb ft).

  4. Remove DT 46551  from the clutch assembly.
  5. Install the transaxle into the vehicle. Refer to Transmission Replacement for the D16 transaxle.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals