LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Swift + >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: Refer to Fastener Notice .
  1. Install the pump to the A/C compressor bracket and tighten the steering pump retaining nuts.

    Tighten:  Tighten the steering pump retaining nuts to 25 N.m (18 lb ft).

  2. Install the A/C compressor mounting bracket and tighten the bolts

    Tighten:  Tighten the A/C compressor mounting bracket bolts to 50 N.m (37 lb ft).

  3. Install the A/C compressor to the bracket. Refer to COMPRESSOR REPLACEMENT .
  4. Install the right side engine under cover.
  5. Install the right front tire. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
    7. Fig 1: Power Steering Fluid/ Pressure & Supply Lines
    GM1248373Courtesy of GENERAL MOTORS CORP.
  7. Connect the pressure and supply lines to the power steering pump.
    8. Fig 2: Air Cleaner Housing & Housing Bolts
    GM1248375Courtesy of GENERAL MOTORS CORP.
  8. Install the air cleaner housing with the housing bolts and the clamp.

    Tighten:  Tighten the air cleaner housing bolts to 12 N.m (106 lb in).

    9. NOTE: Refer to Using Proper Power Steering Fluid Notice .
  9. Refill the pump with new fluid and bleed the air from the system. Refer to Bleeding the Power Steering System .
  10. Inspect for leaks. If leaks are found, correct the cause of the leak and bleed the system.
scientia non olet · About LEMON Manuals