LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Swift + >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation And Air Conditioning >> Repair Instructions >> Condenser Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Liquid Evaporator Pipe Connector Block & Bolt
    GM1251978Courtesy of GENERAL MOTORS CORP.
  1. Install new O-rings onto the receiver-dryer tube fittings.
  2. Ensure that the condenser rubber mounts are in place.
  3. Install the condenser into the vehicle. The lower mount shock protectors must fit into the holes provided.
  4. Move the condenser forward into the radiator support mount holes.
  5. Install the receiver-dryer.
  6. Tighten the band clamp bolt.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the receiver-dryer to the condenser pipe connector block with the nut.

    Tighten:  Tighten the liquid condenser pipe connector block-to-receiver-dryer nut to 10 N.m (89 lb in).

  8. Install the liquid pipe connector block to condenser retaining bolt.

    Tighten:  Tighten the liquid pipe connector block to condenser retaining bolt to 14 N.m (124 lb in).

  9. Install the refrigerant discharge hose connector block bolt at the condenser.

    Tighten:  Tighten the refrigerant discharge hose connector block bolt to 16 N.m (12 lb ft).

    10. Fig 2: Upper Condenser Mount & Nuts
    GM1251980Courtesy of GENERAL MOTORS CORP.
  10. Install the radiator. Refer to Draining and Filling Cooling System in Engine Cooling.
  11. Connect the negative battery cable.
  12. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
scientia non olet · About LEMON Manuals