Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

The conditions that set the DTC are no longer present, the DTC can be cleared by scan tool.

Step	Action	Yes	No
Schematic Reference: Tire Pressure Monitoring System Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Using the scan tool, verify the vehicle speed signal from the TCM. Check the wiring harness between the terminal 2 of TPMS Receiver Module and the terminal B3 (North America Vehicles) or terminal 2 (except North America vehicles) of the cluster. Is there any wiring harness damage (open or ground) or poor connection of connector?	Go to Step 3	Go to Step 4
3	Repair the wiring harness. Is the repair complete?	Go to Step 5	-
4	Replace the TPMS Receiver Module. Perform the TPS ID Registration procedure. Refer to Tire Pressure Monitor System Configuration . Is the repair complete?	Go to Step 5	-
5	Clear the DTCs with the scan tool. Operate the vehicle within the condition for running and setting the DTC. Does the DTC reset?	Go to Step 2	System OK