Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft-To-Knuckle Nut & Shaft-To-Link Nut

Courtesy of GENERAL MOTORS CORP.

Install the stabilizer shaft into the vehicle.

NOTE: Refer to Fastener Notice .

Install the stabilizer shaft-to-knuckle nut and the shaft-to-link nut.
Tighten: Tighten the stabilizer shaft link nuts to 50 N.m (37 lb ft).
Install the front wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.