With Service Bay Test
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Verify the EVAP system repair using the EVAP Service Bay Test
Without Service Bay Test
- Turn the nitrogen/smoke valve to nitrogen.
- Disconnect the EVAP vent line from the vent solenoid, and seal it, using the correct plug from the J 41413-300 .
- Use the remote switch to activate the J 41413-200 .
- Use the remote switch to introduce nitrogen and fill the EVAP system until the floating indicator stabilizes.
- Verify the flow meter's stable floating indicator position is at or below the red flag.
- Clear the DTCs with a scan tool.
IMPORTANT:
The EVAP vent solenoid valve will not remain closed when commanded ON with positive pressure applied to the EVAP system.