Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radiator

Courtesy of GENERAL MOTORS CORP.

Set the radiator into place in the vehicle with the radiator bottom posts in the rubber shock bumpers.

Fig 2: View Of Upper Radiator Retaining Bolt And Bracket

Courtesy of GENERAL MOTORS CORP.

Position the radiator retainers in place.
Install the upper right radiator retaining bracket.

NOTE: Refer to Fastener Notice .

Install the upper right radiator retaining bolt.
Tighten: Tighten the upper right radiator retaining bolt to 7 N.m (62 lb in).

Fig 3: View Of Left Upper Radiator Retaining Bolt And Bracket

Courtesy of GENERAL MOTORS CORP.

Install the upper left radiator retaining bracket.
Install the upper left radiator retaining bolt.
Tighten: Tighten the upper left radiator retaining bolt to 7 N.m (62 lb in).

Fig 4: View Of Surge Tank And Cap

Courtesy of GENERAL MOTORS CORP.

Connect the surge tank hose to the radiator.
Secure the surge tank hose with a hose clamp.

Fig 5: View Of Upper And Lower Radiator Hose

Courtesy of GENERAL MOTORS CORP.

Connect the upper radiator hose and the lower radiator hose to the radiator.
Secure each hose with a hose clamp.
Install the electric cooling fans. Refer to Engine Cooling Fan Replacement .
Refill the engine cooling system. Refer to Cooling System Draining and Filling .
Connect the negative battery cable.