Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Mechanical Control Cables & Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the proper sockets on the back of the controller.
Install the mechanical cable housings to the proper control positions.
Install the eyelets on the end of each cable, pressing each onto the proper post.
Install the controller by gently inserting the controller into the proper position on the center console.

Fig 2: View Of Cable

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the lower left and the lower right controller retaining screws.
Tighten: Tighten the HVAC controller retaining screws to 3 N.m (27 lb in).
Install the audio system. Refer to Radio Replacement (Notchback) or Radio Replacement (Hatchback) .
Connect the negative battery cable.
Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.