LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Swift + >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - 1.6L (L91) - DTC P0016 To DTC P0404 >> DTC P0116 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the ECT sensor.
  2. Ignition ON, clear the DTC information with a scan tool.
  3. Ignition ON, verify that the ECT sensor parameter is at -40°C (-40°F).
    • If greater than -40°C (-40°F), test the signal circuit for a short to ground. If the circuit/connections test normal, replace the ECM.
  4. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit and ground.
    • If greater than 5 ohms, test the low reference circuit of the ECT sensor for an open/high resistance. If the circuit/connections test normal, replace the ECM.
  5. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit/connections test normal, replace the ECM.
  6. Ignition ON, clear the DTC information with a scan tool.
  7. Connect a 1A fused jumper wire between the signal circuit and the low reference circuit. Verify the scan tool ECT sensor parameter is greater than 128°C (262°F).
    IMPORTANT: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.
    • If less than the specified value, test the signal circuit for an open/high resistance. If the circuit/connections test normal, replace the ECM.
  8. If all circuits/connections test normal, test or replace the ECT sensor.
scientia non olet · About LEMON Manuals