LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Swift + >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Wiring Systems >> Diagnostic Information and Procedures >> Repairing Connector Terminals >> Tools Required
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tools Required

J-38125  Terminal Repair Kit. See Special Tools .

Use the following repair procedures in order to repair the following:

Some terminals do not require all of the steps shown. Skip the steps that do not apply for your immediate terminal repair. The J-38125  contains further information. See Special Tools .

  1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.

    For Weather Pack® terminals, remove the seal.

  2. Apply the correct seal per gage size of the wire.

    For Weather Pack® terminals, slide the seal back along the wire in order to enable insulation removal.

  3. Remove the insulation.
  4. For Weather Pack® terminals only, align the seal with the end of the cable insulation.
  5. Position the strip in the terminal.

    For Weather Pack® terminals, position the strip and seal in the terminal.

  6. Hand crimp the core wings.
  7. Hand crimp the insulation wings.

    For Weather Pack® terminals, hand crimp the insulation wings around the seal and the cable.

  8. Solder all of the hand crimp terminals excepting Micro-Pack 100 World terminals. Soldering Micro-Pack 100 World terminals may damage the terminal.
scientia non olet · About LEMON Manuals