DTC P2297: HO2S Performance During Decel Fuel Cut-Off (DFCO) Sensor 1: Troubleshooting
TROUBLESHOOTING CHART
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an On-Board Diagnostic (OBD II) System Check. Was the check performed? |
- | Go to Step 2 | Go to On-Board Diagnostic (OBD II) System Check |
| 2 |
Any other component related Diagnostic Trouble Codes (DTCs) set? |
- | Go to applicable DTC table | Go to Step 3 |
| 3 |
Is the HO2S1 voltage toggle? |
550 mV | Go to Step 4 | Go to "DTC P0134 Oxygen Sensor No Activity" |
| 4 | Check the items in Diagnostic Aids
and repair or replace component as needed. Refer to "Fuel System Diagnosis". Is the repair complete? |
- | Go to Step 6 | Go to Step 5 |
| 5 |
Is the repair complete? |
- | Go to Step 6 | - |
| 6 |
Does the scan tool indicate that this diagnostic has run and passed? |
- | Go to Step 7 | Go to Step 2 |
| 7 | Check if any additional DTCs are set. Are any DTCs displayed that have not been diagnosed? |
- | Go to applicable DTC table | System OK |