LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Premium, Automatic >> Repair and Diagnosis (Single Page) >> Electrical >> Starter >> Starting System >> Repair Instructions >> Starter Motor Disassembly and Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Starter Motor Disassembly and Assembly: Assembly

  1. Install the drive and the pinion stop on the driveshaft.

    See Figure.

  2. Install the lock ring into the groove on the driveshaft and insert the collar.

    See Figure.

  3. Install the shift lever, washer and the cushion.

    See Figure.

  4. Lubricate the drive end of the armature shaft with lubricant.

    See Figure.

  5. Position the solenoid assembly.

    See Figure.

  6. Fasten the solenoid assembly with the screws.

    Tighten: 

    Tighten the starter solenoid assembly screws to 8 N.m (71 lb-in).

  7. Install the field coil connection to the starter terminal. Install the nut.

    Tighten: 

    Tighten the starter field coil connector nut to 8 N.m (71 lb-in).

    See Figure

  8. Position the armature assembly into the field frame.
  9. Place the shield on the armature and field frame assembly.
  10. Install the armature and field frame assembly with the shield into the starter housing.

    See Figure.

  11. Position the commutator end frame/brush holder assembly, lining up the end frame holes with the through-bolt holes in the housing.

    See Figure.

  12. Install the starter through-bolts.
  13. Install the starter. Refer to Starter Removal and Installation .

    Tighten: 

    Tighten the starter through-bolts to 6 N.m (53 lb-in).

    See Figure.

scientia non olet · About LEMON Manuals