Input Shaft and Cluster Gear Disassembly and Assembly

Input Shaft and Cluster Gear Disassembly and Assembly

Tools Required: J-22912-01 Universal Bearing Puller

Disassembly





1. Remove the detent screw at the end of the input driveshaft.





2. Remove the snap ring at the base of the gear cluster.





3. Press the input driveshaft from the input shaft cluster gear using the universal bearing puller J-22912-01.





4. Remove the cluster shaft bearing from the input shaft gear cluster using universal bearing puller J-22912-01.

Assembly





1. Press the cluster shaft bearing onto the input shaft gear cluster.





2. Press the input driveshaft into the input shaft gear cluster assembly.





3. Install the snap ring at the base of the gear cluster.





4. Install the detent screw at the end of the input driveshaft.
^ Tighten the input driveshaft detent screw to 15 Nm (11 ft. lbs.).