LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission >> Repair Instructions >> Shift Linkage Adjustment (Type B)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Shift Linkage Adjustment (Type B)

  1. Disconnect the negative battery cable.
  2. Position the gearshift lever into NEUTRAL.
  3. Loosen the rod clamp bolt. See Figure.
  4. Turn the gearshift rod to push the adjusting pin.
    Fig 1: Turning Gearshift Rod To Push Adjusting Pin
    G00425709Courtesy of SUZUKI OF AMERICA CORP.
  5. Remove the boot from the console.
  6. Pull the boot upward to expose the shift control lever mechanism.
  7. Position the gearshift lever close to left side of the NEUTRAL position.
  8. Insert a 5 mm (0.2 in.) gauge pin into the holes to align the gearshift lever with the gearshift lever housing. See Figure.
  9. Tighten the rod clamp bolt to 14 N.m (124 lb-in). See Figure.
  10. Turn the gearshift rod to release the adjusting pin.
  11. Remove the 5 mm (0.2 inch) gauge pin from the gearshift lever.
    Fig 2: Removing Gauge Pin From Gearshift Lever
    G00425710Courtesy of SUZUKI OF AMERICA CORP.
  12. Install the boot to the console.
  13. Connect the negative battery cable.
scientia non olet · About LEMON Manuals