LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System >> Repair Instructions >> A/C High-Pressure Pipe Line Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

A/C High-Pressure Pipe Line Removal and Installation: Installation

  1. Position the liquid pipe into the vehicle.
  2. Install the liquid pipe support clamp bolts.

    Tighten: 

    Tighten the liquid pipe support clamp bolts to 4 N.m (35 lb-in).

    Fig 1: Identifying Liquid Pipe Support Clamp Bolts
    G04717793Courtesy of SUZUKI OF AMERICA CORP.
  3. Install a new O-ring on the pipe at the receiver dryer.
  4. Install the liquid pipe block-to-receiver-dryer retaining nut.

    Tighten: 

    Tighten the liquid pipe block-to-receiver-dryer retaining nut to 14 N.m (10 lb-ft).

  5. Install the headlamp housing at the right-hand side. Refer to HEADLAMP ASSEMBLY REMOVAL AND INSTALLATION (FOR NOTCHBACK AND STATION WAGON MODEL) and HEADLAMP ASSEMBLY REMOVAL AND INSTALLATION (FOR HATCHBACK MODEL) .
    Fig 2: Identifying Liquid Pipe Block-To-Receiver Dryer Retaining Nut
    G04717792Courtesy of SUZUKI OF AMERICA CORP.
  6. Install the liquid evaporator pipe block retaining nut to the fire wall.

    Tighten: 

    Tighten the liquid pipe block-to-expansion valve retaining nut to 14 N.m (10 lb-ft).

  7. Connect the electrical connector at the pressure transducer.
  8. Install the air cleaner housing bolts and the air filter housing assembly.
    Fig 3: Identifying Liquid Pipe Block-To-Expansion Valve Retaining Nut
    G04717785Courtesy of SUZUKI OF AMERICA CORP.
  9. Position the refrigerant discharge hose into the vehicle.
  10. Install the nut at the condenser connecting block.

    Tighten: 

    Tighten the refrigerant discharge hose block-to-condenser retaining nut to 16 N.m (12 lb-ft).

  11. Install the headlamp housing at the left-hand side. Refer to HEADLAMP ASSEMBLY REMOVAL AND INSTALLATION (FOR NOTCHBACK AND STATION WAGON MODEL) and HEADLAMP ASSEMBLY REMOVAL AND INSTALLATION (FOR HATCHBACK MODEL) .
    Fig 4: Identifying Refrigerant Discharge Hose Block-To-Condenser Retaining Nut
    G04717790Courtesy of SUZUKI OF AMERICA CORP.
  12. Install the nut at the discharge hose block connected to compressor.

    Tighten: 

    Tighten the refrigerant discharge hose block-to-compressor retaining nut to 33 N.m (24 lb-ft).

  13. Connect the negative battery cable.
  14. Evacuate and recharge the A/C system. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .
    Fig 5: Identifying Refrigerant Discharge Hose Block-To-Compressor Retaining Nut
    G04717789Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals