Control Valve Body Assembly Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Disconnect the transaxle wiring harness and the park/neutral position switch electrical connector.

Fig 1: Identifying Park/Neutral Position Switch Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Raise and suitably support the vehicle.
Remove the engine under cover. Refer to ENGINE UNDER COVERS REMOVAL AND INSTALLATION .
Remove the transaxle fluid drain plug using the plug remover/installer DW260-070 and drain the transaxle fluid.

Fig 2: Identifying Plug Remover/Installer DW260-070
Courtesy of SUZUKI OF AMERICA CORP.
Remove the oil pan, oil pan gasket. Refer to Oil Pan, Oil Pan Gasket Removal and Installation .
Remove the valve body mounting bolts.
Remove the automatic transaxle input speed sensor mounting bolt.

Fig 3: Identifying Automatic Transaxle Input Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Tilt the valve body.
Remove the automatic transaxle output speed sensor mounting bolt under the valve body assembly.

Fig 4: Identifying Automatic Transaxle Output Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove the control valve body.

Fig 5: Removing Control Valve Body
Courtesy of SUZUKI OF AMERICA CORP.