LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnostic Information and Procedures >> DTC P1862: EDS 4 Output Shorted to Power >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P1862: EDS 4 Output Shorted to Power: Troubleshooting

WARNING: This page is about a different variant/trim than selected.
TROUBLESHOOTING REFERENCE CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the check completed?		 - Go to Step 2 Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK
2
  1. Install the scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. Select "Actuating" on the scan tool.
  4. Actuate EDS 4 ON/OFF.

Does the EDS 4 change ON/OFF?		 ON/OFF Go to DIAGNOSTIC AIDS Go to Step 3
3
  1. Remove the oil pan.
  2. Disconnect the wiring connector of EDS 4.
  3. Turn the ignition ON, with the engine OFF.
  4. Measure the voltage of EDS 4 wiring connector terminal 1.

Is the voltage within the values shown?		 11 - 14 V Go to Step 4 Go to Step 5
4 Repair the internal line (EDS 4) for a short to power.
Is the repair complete?		 - System OK -
5 Replace the EDS 4.
Is the replacement complete?		 - Go to Step 6 -
6 Check if any DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to applicable DTC table System OK
scientia non olet · About LEMON Manuals