Front Wheel Speed Sensor Removal and Installation: Installation
WARNING: This page is about a different car, the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, and 2007 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front wheel speed sensor to the steering knuckle. Secure it with the bolt.
Tighten:
Tighten the front wheel speed sensor bolt to 8 N.m (71 lb-in).
- Feed the sensor harness into the engine compartment, insert it into the grommet and secure the grommet into the hole in the strut tower.
- Secure the harness into the grommet holders and the clamps under the fender.
- Install the wheel. Refer to WHEEL REMOVAL AND INSTALLATION .
- Lower the vehicle.
- Connect the front wheel speed sensor electrical connector.
- Connect the negative battery cable.