Engine Control Module (ECM) Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If ECM is replaced with new one (VIN data is still not registered) or with used one (VIN data of other vehicle has been registered previously), make sure that re-register VIN in ECM by performing VIN Registration so that VIN can be read by a scan tool.

Installation should follow the removal procedure in the reverse order.
Install the ECM.
Tighten:

Tighten the ECM retaining nuts to 10 - 14 N.m (89 - 124 lb-in.).

Fig 1: Identifying ECM
Courtesy of SUZUKI OF AMERICA CORP.
Tighten the ECM bracket nuts.
Tighten:

Tighten the ECM bracket nuts to 10 - 14 N.m (89 - 124 lb-in.).

Fig 2: Identifying ECM Bracket And Nuts
Courtesy of SUZUKI OF AMERICA CORP.