Control Assembly Removal and Installation: Installation
WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control assembly with the retaining screws to the center molding.
Tighten
Tighten the controller retaining screws to 2 N.m (18 lb-in).
- Press the cable end eyelet onto the post on the controller.
- Attach the mechanical cable housing to its original control position.
- Connect the electrical connectors to the sockets on the back of the controller.
- Gently insert the center molding into position on the instrument panel.
- Connect the negative battery cable.
- Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.