DTC P0565: Cruise Control Switch Circuit: Troubleshooting
WARNING: This page is about a different car, the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, and 2007 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLESHOOTING CHART
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check? | - | Go to Step 2 | Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK |
| 2 | Using the scan tool, view the cruise control ON/OFF switch status parameter. Does the scan tool display active? |
- | Go to Step 4 | Go to Step 3 |
| 3 |
Does the DTC fail this ignition cycle? |
- | Go to Step 4 | Go to Diagnostic Aids |
| 4 |
Does the scan tool display Active? |
- | Go to Step 6 | Go to Step 5 |
| 5 | Replace the cruise control switch. Has the repair been completed? |
- | Go to Step 9 | - |
| 6 | Inspect the cruise control ON/OFF switch signal circuit for a short to voltage. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 7 |
| 7 | Inspect for shorted terminals or poor connections at the ECM wiring harness connector. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 8 |
| 8 | Replace the ECM. Has the repair been completed? |
- | Go to Step 9 | - |
| 9 |
Does DTC P0565 fail this ignition cycle? |
- | Go to Step 2 | System OK |