LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Engine Control System - DTC P0221 Through P0459) >> DTC P0341: Camshaft Position (CMP) Sensor Performance >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
DTC TROUBLESHOOTING CHART

Step Action Value (s) Yes No
1 Perform an ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
Is the system check complete?		 - Go to Step 2. Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK .
2
  1. Turn the ignition switch to LOCK.
  2. Disconnect the CMP sensor connector.
  3. Check for a faulty connector or terminals.

Is the problem found?		 - Go to Step 4. Go to Step 3.
3
  1. Turn the ignition switch to ON.
  2. Disconnect the ECM connector.
  3. Inspect the ECM pins and connector for bent or damaged terminals.
  4. Check the wire between the CMP sensor terminal 2 and ECM connector K32 for an open or short to ground or short to battery voltage.
  5. Check the wires between the CMP sensor terminal 1 and ECM connector K33 for an open.

Is the problem found?		 - Go to Step 4. Go to Step 5.
4
  1. Turn the ignition switch to LOCK.
  2. Repair or replace the wire or the connector.
  3. Clear any DTCs from the ECM.
  4. Run the engine.
  5. Perform the DIAGNOSTIC SYSTEM CHECK .

Is the repair complete?		 - System OK -
5
  1. Turn the ignition switch to LOCK.
  2. Replace the CMP sensor.
  3. Clear any DTCs from the ECM.
  4. Run the engine.
  5. Perform the DIAGNOSTIC SYSTEM CHECK .

Does DTC P0341 reset?		 - System OK Go to Step 6.
6
  1. Replace the ECM.
  2. Run the engine.
  3. Perform the DIAGNOSTIC SYSTEM CHECK .

Is the replacement complete?		 - Go to Step 7. -
7
  1. Using the scan tool, clear the DTCs.
  2. Start the engine and idle at normal operating temperature.
  3. Operate the vehicle within the conditions for setting this DTC as specified in the supporting text.

Does the scan tool indicate that this diagnostic run and passed?		 - Go to Step 8. -
8 Check if any additional DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to applicable DTC Table . System OK
scientia non olet · About LEMON Manuals