Engine Mount Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine mount.
Install the engine mount retaining bolts.
Tighten

Tighten the engine mount retaining bolts to 45 N.m (33 lb-ft).

Fig 1: Installing Engine Mount Retaining Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the timing belt idler pulleys.
Install the timing belt idler pulley bolt and nut.
Tighten

Tighten the timing belt idler pulley bolt and nut to 25 N.m (18 lb-ft).
Tension the timing belt by turning the timing belt automatic tensioner hex-key tab counterclockwise until the pointer is aligned to the indicator.
Tighten

Tighten the timing belt automatic tensioner bolt to 25 N.m (18 lb-ft).

Fig 2: Tightening Timing Belt Automatic Tensioner Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the front timing belt cover.
Install the front timing belt cover bolts.
Tighten

Tighten the front timing belt cover bolts to 6 N.m (53 lb-in).
Install the engine mount bracket and retaining bolts.
Tighten

Tighten the engine mount bracket retaining bolts to 55 N.m (41 lb-ft).
Remove the engine assembly support fixture J-28467-B, and the channel X-28467-560.
Install the serpentine accessory drive belt. Refer to "SERPENTINE ACCESSORY DRIVE BELT REMOVAL AND INSTALLATION :".
Connect the negative battery cable.

Fig 3: Installing Engine Mount Bracket And Retaining Bolts
Courtesy of SUZUKI OF AMERICA CORP.