Front Wheel Speed Sensor Jumper Harness Removal and Installation: Installation

Install the front wheel speed sensor jumper harness.
Connect the front wheel speed sensor electrical connector and secure it into the clamps.

Fig 1: Identifying Front Wheel Speed Sensor Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Replace the jumper harness into the wiring harness.
Insert the terminals into connector as they had been removed:
- Right-side - terminals 4 (WHT) and 5 (GRY) (2006) or terminals 5 (WHT) and 6 (GRY) (2007).
- Left-side - terminals 6 (BRN) and 7 (LT BLU) (2006) or terminals 9 (BRN) and 8 (LT BLU) (2007).
Connect EBCM connector.
Connect the negative battery cable.

Fig 2: Identifying 2006 EBCM Connector
Courtesy of SUZUKI OF AMERICA CORP.

Fig 3: Removing/Installing 2007 EBCM Connector
Courtesy of SUZUKI OF AMERICA CORP.