LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Manifold Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Exhaust Manifold Removal and Installation: Installation

  1. Install the exhaust manifold gasket.
  2. Install the exhaust manifold.
  3. Install the exhaust manifold retaining nuts and tighten in the sequence shown.

    Tighten: 

    Tighten the exhaust manifold retaining nuts 22 N.m (16 lb-ft).

    See Figure.

  4. Install the exhaust flex pipe retaining nuts to the exhaust manifold studs.

    Tighten: 

    Tighten the exhaust flex pipe-to-exhaust manifold retaining nuts to 35 N.m (26 lb-ft).

    See Figure.

  5. Install the exhaust manifold heat shield.
  6. Install the exhaust manifold heat shield bolts.

    Tighten: 

    Tighten the exhaust manifold heat shield bolts to 8 N.m (71 lb-in).

  7. Connect the O2 sensor connector, if equipped.
  8. Connect the negative battery.

    See Figure.

scientia non olet · About LEMON Manuals