LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Reno Base, Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Column >> Repair Instructions >> Steering Wheel Speed Sensor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Wheel Speed Sensor Removal and Installation: Removal

  1. Disconnect the negative battery cable.
  2. Remove the upper and the lower instrument trim panels. Refer to INSTRUMENT CLUSTER TRIM PANEL REMOVAL AND INSTALLATION .
  3. Disconnect the steering wheel speed sensor electrical connector.
    Fig 1: Identifying Steering Wheel Speed Sensor Electrical Connector
    G04717640Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove the intermediate shaft from the steering column to allow removal of the steering wheel speed sensor. Refer to INTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATION .
  5. Remove the retaining screw from the steering wheel speed sensor.
  6. Remove the steering wheel speed sensor.
    Fig 2: Identifying Retaining Screw And Steering Wheel Speed Sensor
    G04717641Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals