Transmission Shift Control Lever Removal And Installation: Installation

Reference: TRANSMISSION SHIFT CONTROL LEVER INSPECTION 

1. Tighten new control lever locating bolts (1) to specified torque, if removed.

   Tightening torque 

   Control lever locating bolt a: 10 N.m (1.0 kg-m, 7.5 lb-ft) 

2. Apply grease to pivot portions and seat, then install shift control lever.

   "A": Grease 99000-25010SUZUKI Super Grease A 

   Fig 1: Identifying Control Lever Locating Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
3. Set shift control lever (2) to gear shift lever rear case.
4. Install case cover (1) to gear shift lever rear case (3). Tighten case cover bolt to specified torque.

   Tightening torque 

   Case cover bolt a: 10 N.m (1.0 kg-m, 7.5 lb-ft) 

   Fig 2: Identifying Case Cover & Gear Shift Lever Rear Case

   Courtesy of SUZUKI OF AMERICA CORP.
5. Install sheet, boot (1) with boot cover (2) to floor panel.

   Tightening torque 

   Control lever boot cover bolt a: 12 N.m (1.2 kg-m, 9.0 lb-ft) 

   Fig 3: Identifying Sheet, Boot With Boot Cover

   Courtesy of SUZUKI OF AMERICA CORP.
6. Install front console box referring to CONSOLE BOX COMPONENTS .