P/S Pump Removal And Installation: Installation

Reverse removal procedure, and then noting the following instructions.

NOTE:

Adjust P/S pump drive belt referring to P/S PUMP AND A/C COMPRESSOR (IF EQUIPPED) DRIVE BELT INSPECTION AND ADJUSTMENT .
Fill specified power steering fluid after installation and bleed air without failure. (Refer to P/S SYSTEM AIR BLEEDING PROCEDURE ).

Tightening torque

P/S pump mounting bolt: 25 N.m (2.5 kg-m, 18.0 lb-ft)

P/S pump high pressure pipe union bolt: 60 N.m (6.0 kg-m, 43.5 lb-ft)