ID Registration Without Suzuki Scan Tool

Confirm that all doors are closed and ignition mode of keyless push start system is OFF.
Open driver side door.
Perform the following Steps a) to c) within 15 seconds after ignition switch turned ON:
1. Press driver side door switch hand within 5 seconds after ignition mode is ON. Keep the switch pressed for 2 seconds.
2. Release driver side door switch and then press driver side door switch for 2 seconds or more by hand.
3. Release driver side door switch and then press driver side door switch for 2 to 5 seconds by hand.
Using recommended tool VT55 at tire pressure sensor, activate each sensor within 180 seconds.
When tire pressure sensor is activated, ID code of tire pressure sensor is registered automatically in keyless start control module. When "ID code registration status" indicated on Suzuki scan tool is "Complete", registration has been completed. If "Time Out" is indicated, perform all the registration procedures again. Also, it is possible to check the number of ID codes of tire pressure sensors received by keyless start control module by observing the flashing pattern of low tire pressure warning light
NOTE: If registration of tire pressure sensor ID codes are not completed within 180 seconds, former ID codes remain in keyless start control module. Therefore, perform the above steps again.

NOTE: When keyless start control module receives each ID code of 4 tire pressure sensors, keyless start control module turns ON low tire pressure warning light in combination meter for 5 seconds.
Push engine switch to change ignition mode to OFF after registration is completed.