LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Grand Vitara Premium, RWD, Standard >> Repair and Diagnosis >> General Information >> Reset Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 04 >> TPM Learn Mode Cancellation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TPM Learn Mode Cancellation

The learn mode will cancel if more than 2 minutes have passed and no sensor have been learned, or if more than 5 minutes has passed for the entire procedure. If the learn mode is canceled before any Ids are learned, the RCDLR will remember all previously stored Ids and their locations. As soon as the RCDLR learns the first ID, all other Ids are erased from the RCDLR's memory.

NOTE: Before proceeding with the steps below, ensure that no other sensor learn procedure is being performed simultaneously, or that tire pressures are not being adjusted on a TPM equipped vehicle within close proximity.
  1. Turn ON the ignition, with the engine OFF.
  2. Apply the parking brake.
    NOTE: If the learn mode cannot be enabled, ensure the TPM system is enabled in the RCDLR. Refer to CONTROL MODULE REFERENCES .
  3. Enable learn mode:
    • Driver Information Center (DIC) Method:  Press the vehicle information button until the RELEARN TIRE POSITIONS message displays. If your vehicle does not have the DIC buttons, press the trip odometer reset stem located on the instrument panel cluster until the RELEARN TIRE POSITIONS message displays. If your vehicle has the DIC buttons, press the set/reset button. The horn will sound twice to indicate the TPMs receiver is ready, and the TIRE LEARNING ACTIVE message will display. If your vehicle does not have the DIC buttons, press and hold the trip odometer reset stem until the horn chirps twice and the TIRE LEARNING ACTIVE message is displayed.
    • Alternate Methods:  Simultaneously press the keyless entry transmitters lock and unlock buttons until a horn chirp sounds or use the scan tool and select Special Functions/Sensor Learn Mode Enable/Enable soft key. A horn chirp will sound indication that learn mode has been enabled.
  4. Starting with the Left Front tire, hold the antenna of the J-46079 against the tire sidewall close to the wheel rim at the valve stem location then press and release the activate button and wait for a horn chirp, or increase/decrease the tire pressure for 8-10 seconds then wait for a horn chirp. The horn chirp may occur before the 8-10 second pressure increase/decrease time period has been reached, or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached.
  5. After the horn chirp has sounded, proceed as in step  4 for the next 3 sensors in the following order: Right Front, Right Rear, Left Rear
  6. After the Left Rear sensor has been learned, turn OFF the ignition to exit the learn mode.
  7. After the learn mode has been exited, adjust all tire pressures to the recommended PSI.
scientia non olet · About LEMON Manuals