Transmission Range Sensor Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Install transmission range sensor (3) and tighten sensor bolt (4) temporarily.
Install grommet, lock washer (1) and manual shift shaft nut (2).
Tighten nut to specified torque. After tightening it, bend claws of lock washer (1).

Tightening torque

Manual shift shaft nut a: 7 N.m (0.7 kg-m, 5.0 lb-ft)
After turning manual shift shaft fully counterclockwise, turn it clockwise by 2 notches and set it to "N" range.
With "N" reference line (5) on range sensor and shaft center (6) aligned, tighten transmission range sensor bolt (4) to specified torque.
Tightening torque

Transmission range sensor bolt b: 13 N.m (1.3 kg-m, 9.5 lb-ft)

Fig 1: Identifying Reference Line On Range Sensor
Courtesy of SUZUKI OF AMERICA CORP.
Connect transmission range sensor connector (1).
Connect negative cable at battery.

Fig 2: Identifying Transmission Range Sensor Connector
Courtesy of SUZUKI OF AMERICA CORP.