Transmission Fluid Temperature Sensor A And B Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect negative cable at battery.
Pull out fluid level gauge and lift up vehicle.
Remove exhaust No. 1 pipe (1).
Remove drain plug (2) and drain A/T fluid.
Install drain plug (2).

Fig 1: Identifying Exhaust No. 1 Pipe & Drain Plug
Courtesy of SUZUKI OF AMERICA CORP.
Remove A/T oil pan (1).

Fig 2: Identifying A/T Oil Pan
Courtesy of SUZUKI OF AMERICA CORP.
Remove A/T oil strainer (1).

Fig 3: Identifying A/T Oil Strainer
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect shift solenoid-A connector (1), shift solenoid-B connector (2), shift solenoid-E connector (3), TCC solenoid connector (4), Pressure control solenoid-A connector (5), Pressure control solenoid-B connector (6) and Pressure control solenoid-C connector (7).
Remove solenoid valves.

Fig 4: Identifying Shift Solenoid Connectors & TCC Solenoid Connector
Courtesy of SUZUKI OF AMERICA CORP.
After removing bolt (1) pull out transmission wire connector (2) from transmission case.
CAUTION: When pulling transmission wire harness out of transmission case, take care not to damage connectors and transmission fluid temperature sensors at narrow exist of case. Careless sensor treatment might cause sensor malfunction.

Fig 5: Identifying Bolt & Transmission Wire Connector
Courtesy of SUZUKI OF AMERICA CORP.