Select Cable Adjustment

WARNING: This page is about a different variant/trim than selected.

Remove manual selector, refer to MANUAL SELECTOR ASSEMBLY REMOVAL AND INSTALLATION with select cable connected.
Loosen manual select cable end nut (1).
Shift select lever (2) and manual select lever (3) to "N".
Tighten manual select cable end nut (1) to specified torque.
Tightening torque

Manual select cable end nut a: 13 N.m (1.3 kg-m, 9.5 lb-ft)

Fig 1: Identifying Select Cable End Nut & Shift Select Lever
Courtesy of SUZUKI OF AMERICA CORP.
After select cable was installed, check for the following.
- Push vehicle with selector lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "4" and "L".
- Vehicle can be backed in "R".