DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTCs in TCM and ECM memories by using scan tool.
- Start engine and shift select lever to "D" range.
- Start vehicle and increase vehicle speed to 60 km/h (37 mile/h) in "D" range.
- Keep on driving in the speed for 20 seconds and decrease vehicle speed gradually.
- Stop vehicle.
- Check DTC, pending DTC and freeze-frame data.