Input Shaft Speed Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara and 2007 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Check that sensor is free from any metal particles and damage.
Apply A/T fluid to new O-ring and then install input shaft speed sensor (1) to transmission. Tighten sensor bolt to specified torque.
Tightening torque

Input shaft speed sensor bolt a: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)

Fig 1: Identifying Input Shaft Speed Sensor Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Connect input shaft speed sensor connector.
Lower hoist.
Connect negative cable at battery.