LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Grand Vitara Premium, RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Front Suspension) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Take care not to catch the transmission shift cable or left wheel house plastic trim when installing the stabilizer shaft.
  1. Install the stabilizer shaft to the vehicle through the left wheel opening.
    Fig 1: Identifying Stabilizer Shaft Clamp Bolts
    G04842720Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the stabilizer shaft clamps and bushings to the stabilizer bar.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the stabilizer shaft clamp bolts.

    Tightening torque 

    Tighten the bolts to 50 N.m (37 lb ft)  .

    Fig 2: Identifying Stabilizer Shaft Link Ball Stud
    G04842721Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the stabilizer shaft link ball stud to the stabilizer shaft. Refer to STABILIZER SHAFT LINK REPLACEMENT .
  5. Install the left and right outer tie rod ends on the knuckle. Refer to RACK AND PINION OUTER TIE ROD END REPLACEMENT .
  6. Install the front tire and wheels. Refer to INSTALLATION PROCEDURE .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals