Adjustment Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Remove the left instrument panel (I/P) insulator panel. Refer to INSTRUMENT PANEL INSULATOR PANEL REPLACEMENT - LEFT SIDE .

Fig 1: Identifying Stop Lamp Switch Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION:
Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.
Disconnect the electrical connector from the stop lamp switch.

Fig 2: Removing Switch From Switch Retainer
Courtesy of SUZUKI OF AMERICA CORP.
Rotate the switch counterclockwise and remove the switch from the switch retainer.
NOTE:
Do NOT depress the brake pedal assembly during the stop lamp switch installation. This will cause a drag condition on the brake.
Install the switch to the bracket by turning and pushing the switch until the switch bottoms on the brake pedal.
Connect the electrical connector to the stop lamp switch.
Inspect the stop lamps for proper operation
Install the left I/P insulator panel. Refer to INSTRUMENT PANEL INSULATOR PANEL REPLACEMENT - LEFT SIDE .