Engine and Emission Control System Check: Notes

WARNING: This page is about a different car, the 2007 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Numbers of each step correspond to the numbers of the items after this table.

Refer to the following items for the detail of each step.

TROUBLESHOOTING TABLE

Step	Action	YES	NO
1	Customer complaint analysis Perform customer complaint analysis. Was customer complaint analysis performed?	Go to Step 2.	Perform customer complaint analysis.
2	DTC freeze frame data check, record and clearance Check DTC (including pending DTC), referring to DTC CHECK . Is there any malfunction DTC?	Print DTC and freeze frame data or write them down and clear them by referring to DTC CLEARANCE , and go to Step 3.	Go to Step 4.
3	Visual inspection Perform visual inspection by referring to VISUAL INSPECTION . Is there any faulty condition?	Repair or replace malfunction part, and go to Step 11.	Go to Step 5.
4	Visual inspection Perform visual inspection referring VISUAL INSPECTION . Is there any faulty condition?	Repair or replace malfunction part, and go to Step 11.	Go to Step 8.
5	Trouble symptom confirmation Confirm trouble symptom based on customer complaint analysis, DTC freeze frame data in Step 1. Is trouble symptom identified?	Go to Step 6.	Go to Step 7.
6	Rechecking and record of DTC freeze frame data Recheck DTC freeze frame data. Is there any malfunction DTC?	Go to Step 9.	Go to Step 8.
7	Rechecking and record of DTC freeze frame data Recheck DTC freeze frame data. Is there any malfunction DTC?	Go to Step 9.	Go to Step 10.
8	Engine basic inspection and engine symptom diagnosis Check and repair according to VISUAL INSPECTION and ENGINE SYMPTOM DIAGNOSIS . Are check and repair complete?	Go to Step 11.	Check and repair malfunction part(s), and go to Step 11.
9	Troubleshooting for DTC Check and repair according to the "DTC Troubleshooting" of the applicable DTC flow. Are check and repair complete?	Go to Step 11.	Check and repair malfunction part(s), and go to Step 11.
10	Intermittent problems check Check for intermittent and poor connection. Is there any faulty condition?	Repair or replace malfunction part, and go to Step 11.	Go to Step 11.
11	Final confirmation test Clear DTC if any. Perform final confirmation test by referring to each DTC CONFIRMATION PROCEDURE . Is there any problem symptom, malfunction DTC or abnormal condition?	Go to Step 6.	End.