Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Assist Lever On Top Of Connector

Courtesy of SUZUKI OF AMERICA CORP.

Locate the assist lever on the top of the connector. Move the assist lever to the forward position.

Fig 2: Disconnecting Connector From Component
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect the connector from the component.

Fig 3: Releasing Locking Tabs With Small Flat-Blade Tool
Courtesy of SUZUKI OF AMERICA CORP.
Locate the dress cover locking tabs at the corners of the connector. Use a small flat-blade tool to release the locking tabs and remove the dress cover.

Fig 4: Identifying Terminal Positive Assurance (TPA)
Courtesy of SUZUKI OF AMERICA CORP.
The terminal positive assurance (TPA) is located in the front of the connector.

Fig 5: Releasing TPA From Connector With Small Flat-Blade Tool
Courtesy of SUZUKI OF AMERICA CORP.
Use a small flat-blade tool to remove TPA from the connector.

Fig 6: Inserting Tool Into Terminal Release Cavity
Courtesy of SUZUKI OF AMERICA CORP.
Use the J 38125-213 or the J 38125-556 (GM P/N 12093647) tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.