DTC Troubleshooting
DTC TROUBLESHOOTING CHART
| Step |
Action |
YES |
NO |
| 1 |
Was "Engine and Emission Control System Check" performed? |
Go to Step 2. |
Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK . |
| 2 |
Fuel level sensor performance check
- Check fuel level sensor (main and sub) for performance referring to FUEL LEVEL SENSOR INSPECTION
.
Is it in good condition? |
Substitute a known-good ECM and recheck. |
Replace main and/or sub fuel level sensor. |
| 3 |
Wire harness check
- Disconnect connectors from ECM with ignition switch turned OFF.
- Check for proper terminal connection to fuel level sensor (main and sub) and ECM connectors.
- If connections are OK, check that fuel level sensor circuit is as follows.
- Wiring harness resistance of fuel level sensor (main and sub) circuit is less than 3Ω.
- Insulation resistance of fuel level sensor (main and sub) circuit is infinity between fuel level sensor (main and sub) connector and vehicle body ground.
- Insulation resistance of wire harness is infinity between fuel level sensor (main and sub) terminal and each other terminal at fuel level sensor connector.
- Circuit voltage of fuel level sensor (main and sub) circuit is 0 - 1 V with ignition switch turned ON.
Are they in good condition? |
Substitute a known-good ECM and recheck. |
Repair or replace defective wire harness. |