DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- With ignition switch OFF, connect scan tool to DLC.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm it up to normal operating temperature.
- Run engine at 2000 RPM and increase engine speed to 5000 RPM and then decrease it to 2000 RPM noting in order not to close throttle valve.
- Repeat step 4) 4 times.
- Stop vehicle and check DTC and pending DTC.