DTC Troubleshooting
DTC TROUBLESHOOTING CHART
| Step |
Action |
YES |
NO |
| 1 |
Was "Engine and Emission Control System Check" performed? |
Go to Step 2. |
Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK . |
| 2 |
Wire harness check
- Disconnect connectors from EVAP leak check module and ECM with ignition switch turned OFF.
- Check for proper terminal connection to EVAP leak module and ECM connectors.
- If connections are OK, check EVAP leak detection pump circuit is as follows.
- Wiring harness resistance of each EVAP leak detection pump control and ground circuits is less than 3Ω
- Insulation resistance of EVAP leak detection pump control circuit is infinity between EVAP leak check module connector and vehicle body ground
- Insulation resistance of wire harness is infinity between EVAP leak detection pump control terminal and each other terminal at EVAP leak module connector
- Circuit voltage of EVAP leak detection pump control circuit is 0 - 1 V with ignition switch turned ON
Are they in good condition? |
Go to Step 3. |
Repair or replace control and ground circuits of EVAP leak detection pump. |
| 3 |
EVAP leak detecting pump check
- Check EVAP leak detecting pump for operation referring to "EVAP Leak Detecting Pump Check" under EVAP LEAK CHECK MODULE INSPECTION
.
Is it in good condition? |
Substitute a known-good ECM and recheck. |
Replace EVAP leak check module. |