DTC Confirmation Procedure
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE ".
- Intake air temperature: 70°C (158°F) or higher.
- Engine coolant temperature at engine start: between -10°C (14°F) and 56°C (133°F).
- The following to DTCs are not detected: MAF sensor, IAT sensor and ECT sensor (other than P0128).
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch, clear DTC if any.
- Start engine and run it for 20 minutes.
- Check DTC and pending DTC by using scan tool.