DTC Confirmation Procedure
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE ".
- Intake air temperature: between -14 °C and 70 °C (6.8 °F and 158 °F).
- Engine coolant temperature: higher than 20 °C (68 °F).
- Atmospheric pressure: higher than 75 kPa (560 mmHg) (Altitude: lower than 2790 m (9150 ft).
- The following DTC(s) are not detected: fuel system, ECT sensor, barometric pressure sensor, IAT sensor, VSS, MAT sensor, EVAP canister purge valve and APP sensor.
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Keep engine at idle speed for 30 sec.
- Check DTC and pending DTC by using scan tool.