DTC Troubleshooting
DTC TROUBLESHOOTING CHART
| Step |
Action |
YES |
NO |
| 1 |
Was "Engine and Emission Control System Check" performed? |
Go to Step 2. |
Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK . |
| 2 |
EGR valve power supply circuit check
- With ignition switch OFF, disconnect connector from EGR valve.
- With ignition switch ON, check that EGR valve power supply circuit voltage between.
- "a" terminal of EGR valve connector and vehicle body ground is battery voltage.
- "b" terminal of EGR valve connector and vehicle body ground is battery voltage.
Is it in good condition? |
Go to Step 3. |
EGR valve power supply circuit is open or shorted to ground. |
| 3 |
Wiring harness check
- Disconnect connectors from ECM with ignition switch turned OFF.
- Check for proper terminal connection to EGR valve and ECM connectors.
- If connections are OK, check that EGR valve control circuit is as follows.
- Wiring harness resistance of all EGR valve control circuits are less than 3 Ω.
- Insulation resistance between all EGR valve control circuits and vehicle body ground are infinity.
Are they in good condition? |
Go to Step 4. |
Repair or replace defective wire harness. |
| 4 |
EGR valve check
- Check EGR valve for resistance referring to EGR VALVE ASSEMBLY INSPECTION
.
Is it in good condition? |
Substitute a known-good ECM and recheck. |
Replace EGR valve. |